Mobile Mechanics Auckland

Silver Service

Full Test and Check of Your:

  • Check and replace engine oil
  • Replace oil filter
  • Check Power steering fluid
  • Test Battery
  • Window blades and fluid and horn
  • Radiator and coolant levels and condition of both
  • Clutch and brake master cylinder fluid levels
  • Battery fluid
  • Check Engine for oil and engine leaks
  • Transmisson Fluid, pan filter and pan Gasket (if applies)
  • Transmission/Manual Gearbox oil (as applies)
  • Brake fluid drained and replaced (if applies)
  • Check Carburettor/Throttle body and Security
  • Inspect idle stop solonoid (as applies)
  • Idle speed/mixture adjustment (if applicable)
  • Inspect feul rail for security and condition
  • Diff and transaxle fluid
  • Full 15 Point check

 

Inspect and Full Checks on:

  • Radiator and heater cores inspected
  • Heater tap
  • Vaccum lines and hoses inspected
  • Visual check cooling system hoses
  • Pressure check cooling system
  • Water pump and fan clutch
  • Hose clamps Pressure, cooling system
  • Fan belt adjusted as required
  • Transmission
  • Battery Electrolyte level
  • Battery Terminals inspection
  • Power supply Cables checked for security
  • Window Blades
  • Air filter
  • Feul hoses checked secured as needed
  • Test brake lights. indicator and side and headlights
  • Check steering componets
  • Check Lubricate for steering stops
  • Tyre pressure adjust as required and apply shine
  • Check All brakes
  • Check WOF expiry
  • Fuel filter check
  • Checks of fan Vee belts
  • Spark plug checked for wear and ignition componets

 

Inspect and Full Checks on:

  • Ignition leads inspected (bum marks/wear)
  • Check Voltage output of ignition coils and condition
  • Main engine earth check
  • Adjust hand brakes
  • Check Exhaust secureand for leaks
  • Replace wiper refill
  • Check Drive belts
  • Shock absorber/struts checked
  • Anaylse of exhaust gas
  • Timing checks of ignition checked (if applicable)
  • Cambelt tested
  • Check Altamator voltage output under load
  • Check starter motor for current draw
  • Test park neutral switch operation
  • Check mounting of power supply cables
  • Check EFI Componets for security of operation
  • Clean dash Board/empty ash tray
  • Emmission Control System check
  • Complete Engine Compression Test
  • Check Feul injectors (as applies)
  • Check Tappets or lifters for noise and report
  • Inspect and check on timing belt
  • Test operation of EGR valve
  • Road test: Engine performance, braking
  • Repack front and rear wheel bearings (if applicable)
  • CV boot. driveline inspection
  • Road test: Check of braking system. steering
  • Suspension and overall accessories and lights